89110 JET Ford Module | Auto Transmission
Performance tuning is more difficult on Ford vehicles since the factory computer does not have a chip that can be easily replaced. To solve the problem JET developed a plug in module that attaches to the vehicle computer externally that can add up to 30 horsepower. The JET Ford Module optimizes the ignition spark advance, air to fuel ratios and transmission shifting for the ultimate in power and mileage gains. JET’s exclusive Dynamic Spectrum Tuning provides optimal performance across the entire power band-not just at full throttle. Great for towing or SUV applications, all out street performance cars and everyday drivers. Daily drivers can use lower cost regular fuel for potential mileage gains, but for optimal performance gains use of mid-grade or better is recommended. Improves throttle response, acceleration and low end torque. Simple, plug-in installation in less than 30 minutes. Also works well with aftermarket intake and exhaust systems, mass air sensors, TBI spacers, etc. Installation Instructions
View Compatible Vehicles$333.95
Performance tuning is more difficult on Ford vehicles since the factory computer does not have a chip that can be easily replaced. To solve the problem JET developed a plug in module that attaches to the vehicle computer externally that can add up to 30 horsepower. The JET Ford Module optimizes the ignition spark advance, air to fuel ratios and transmission shifting for the ultimate in power and mileage gains. JET’s exclusive Dynamic Spectrum Tuning provides optimal performance across the entire power band-not just at full throttle. Great for towing or SUV applications, all out street performance cars and everyday drivers. Daily drivers can use lower cost regular fuel for potential mileage gains, but for optimal performance gains use of mid-grade or better is recommended. Improves throttle response, acceleration and low end torque. Simple, plug-in installation in less than 30 minutes. Also works well with aftermarket intake and exhaust systems, mass air sensors, TBI spacers, etc. Installation Instructions
# 89110
Additional information
| Weight | 1 lbs |
|---|
1 review for 89110 JET Ford Module | Auto Transmission
Add a review
Related Products
10610 Power Control Module | Stage 1
#10610
79509 JET Ford Module | Manual Transmission
#79509
21410S Power Control Module | Stage 2
#21410S
16008 E-Z Tune Programmer
#16008
19207S Computer Chip | Stage 2 | Auto Transmission
#19207S
Jeffrey Lofsted (verified owner) – :
It all starts with no paper instructions just a QR code. You would think no problem you scan the code and presto instructions on line. No the QR code just gets you to the HOME PAGE for Jet Performance. Not to a set of comprehensive instructions. So when you eventually find your way to instructions. They are so vague the instructions could have been printed on a match book cover. Once installed you can no longer secure the ECM with the existing bracket. As a matter of fact there is nothing to secure it after the installation. It also leaves the ECM susceptible to dust and moisture. Once you accept all those uncertainties. You reconnect the battery and start your vehicle. Yes it runs . It runs and drives fine. It runs and drives like it did before you purchased the Jet Performance module. If it does give you up to 30 hp and increased mpg. Let’s just say I haven’t noticed any increase of hp but I’m still hoping for better mpg.
JET Performance – :
Hello Jeffery, the QR code, goes to the installation Instructions Page where you select the product you purchased. If you did the install properly (with unplugging the battery during the install and then plugging the battery back in) You will see a difference and then after the computer does the relearn after you drive the vehicle for a little bit you will see the difference after the complete relearn.
The module has rubber seals around where it connects to the ECU, there are also brackets on the module that locks it into place so the seal will combat; coming loose, preventing dirt, water and dust.